Technically Speaking, Inc
DSP Design Using System Generator | Online & Onsite - Phoenix AZ
Please note: This course is scheduled to run Onsite and Online simultaneously. If there is not adequate enrollment for Onsite, it may run in the Online version only.
Onsite and Online versions of this course have the exact same material and content.
This course allows you to explore the System Generator tool and to gain the expertise you need to develop advanced, low-cost DSP designs. This intermediate course in implementing DSP functions focuses on learning how to use System Generator for DSP, design implementation tools, and hardware co-simulation verification. Through hands-on exercises, you will implement a design from algorithm concept to hardware verification using the Xilinx FPGA capabilities.
- Introduction to System Generator
- Simulink Software Basics
- Lab 1: Using the Simulink Software
- Basic Xilinx Design Capture
- Demo: System Generator Gateway Blocks
- Lab 2: Getting Started with Xilinx System Generator
- Signal Routing
- Lab 3: Signal Routing
- Implementing System Control
- Lab 4: Implementing System Control
- Multi-Rate Systems
- Lab 5: Designing a MAC-Based FIR
- Filter Design
- Lab 6: Designing a FIR Filter Using the FIR Compiler Block
- System Generator, Vivado Design Suite, and Vivado HLS Integration ▪ Lab 7: System Generator and Vivado IDE Integration
- Kintex-7 FPGA DSP Platforms
- Lab 8: System Generator and Vivado HLS Tool Integration
- Lab 9:
- AXI4-Lite Interface Synthesis
- Lab 1: Using the Simulink Software – Learn how to use the toolbox blocks in the Simulink software and design a system. Understand the effect sampling rate.
- Lab 2: Getting Started with Xilinx System Generator – Illustrates a DSP48-based design. Perform hardware co-simulation verification targeting a Xilinx evaluation board.
- Lab 3: Signal Routing – Design padding and unpadding logic by using signal routing blocks.
- Lab 4: Implementing System Control – Design an address generator circuit by using blocks and Mcode.
- Lab 5: Designing a MAC-Based FIR – Using a bottom-up approach, design a MAC-based bandpass FIR filter and verify through hardware co-simulation by using a Xilinx evaluation board.
- Lab 6: Designing a FIR Filter Using the FIR Compiler Block – Design a bandpass FIR filter by using the FIR Compiler block to demonstrate increased productivity. Verify the design through hardware co-simulation by using a Xilinx evaluation board.
- Lab 7: System Generator and Vivado IDE Integration – Embed System Generator models into the Vivado IDE.
- Lab 8: System Generator and Vivado HLS Tool Integration – Generate IP from a C-based design to use with System Generator.
- Lab 9: AXI4-Lite Interface Synthesis – Package a System Generator for DSP design with an AXI4-Lite interface and integrate this packaged IP into a Zynq All Programmable SoC processor system.
* This course focuses on the 7 series architectures. Check with your local Authorized Training Provider for the specifics of the in-class lab board or other customizations. The ZC702 or ZedBoard is required for the "AXI4-Lite Interface Synthesis" lab.
After completing this comprehensive training, you will have the necessary skills to:
- Describe the System Generator design flow for implementing functions
Identify Xilinx FPGA capabilities and how to implement a design from algorithm concept to hardware simulation
List various low-level and high-level functional blocks available in System Generator
Run hardware co-simulation
Identify the high-level blocks available for FIR and FFT designs
Implement multi-rate systems in System Generator
Integrate System Generator models into the Vivado IDE
Design a processor-controllable interface using System Generator for DSP
Generate IPs from C-based design sources for use in the System Generator environment